tag:blogger.com,1999:blog-24638140.post2099521911179575462..comments2023-08-18T04:17:09.026-05:00Comments on CAD-e-Corner: Setting Hatch Boundary boundariesWard Rombergerhttp://www.blogger.com/profile/04148957596186935597noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-24638140.post-47937174897624158052008-02-08T15:40:00.000-06:002008-02-08T15:40:00.000-06:00the problem with doing it as the first anon commen...the problem with doing it as the first anon commenter suggested is if you are hatching something curved or want the hatch to uniformly cover a line, there is no quick way to do this with polyline/line command. it would take a long time. the way the article describes sounds like it will be faster than attempting to draw a hatch boundary w/ pline around a line. thanks for the directions - i will test it out.Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-24638140.post-83322602079360044152007-08-08T10:43:00.000-05:002007-08-08T10:43:00.000-05:00regarding the 1st post - I disagree. it's actuall...regarding the 1st post - I disagree. it's actually faster NOT creating a new layer and new entity to hatch a boundary... especially some of the complex boundaries I hatch.Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-24638140.post-26734187164884858702007-05-08T04:40:00.000-05:002007-05-08T04:40:00.000-05:00very long winded. create a layer called hatchbound...very long winded. create a layer called hatchboundary, draw a polyline as your boundary and hatch this. just make sure the hatch boundary layer is set not to plot.Anonymousnoreply@blogger.com